OnyxOperation6Ad-hoc ModeIf you have a Mac or PC computer, or other phone or tablet, use the following methodto connect to the system:1. Put the Harman Kardon Onyx into Ad-hoc mode by touchingthe Wi-Fi button for more than 5 seconds (ensure thereare no USB devices plugged into the USB port).2. Go to the Wi-Fi Settings page on your Mac, PC or Phone andconnect to the network with the name HK_Onyx*****.This may take around 40 seconds depending on your device.3. Open your web browser and enter the IP address as192.168.1.1 in the address bar of your browser.The following page will be displayed.4. Select the name of the Wi-Fi network you want to connectfrom the drop-down menu Device Wireless SSID.5. Enter the password for your network and click Connect.A warning box will be displayed.6. Ensure that you have entered the password correctly. If you are not sure,click Cancel and enter the password again without any mistake.The Harman Kardon Onyx will then attempt to connect to your Wi-Fi network. If theconnection is successful, the Wi-Fi LED will turn white and the connection successfultone can be heard.NOTE: To restore the factory default settings, long press Bluetooth andPower button in Operational mode.OperationSwitching ON and OFFThe power button on the top panel of the speaker allows you to set your speaker to anyof the following power modes:• Operational mode – White constant LED illumination• Sleep mode – Amber constant LED illumination• OFF mode – No illuminationTo change the power mode:• Short press - Operational/Sleep mode: show battery status• Long press - OFF mode: wake up to Operational mode, Operational/Sleepmode: enter OFF modeAdjusting VolumeThe volume buttons on the top panel allow you to increase or decrease volume. Thesebuttons are touch-sensitive, allowing volume control with a gentle finger-touch of thebuttons. Adjust volume using the Volume Up (“+”) and Volume Down (“–”) buttonslocated on top of the unit.• Short press - Increase/decrease volume by 1 step• Press and hold - Increase/ decrease volume continuously (1 step per 0.2second)Playing Music through Bluetooth1. Press the Power button. The LED will illuminate white.The HK Onyx enters pairing mode the first time it is switched on.2. If HK Onyx has been paired with any source before, touchand hold the Bluetooth button for at least 4 seconds.3. Perform a new device search on your Bluetooth-capable device.4. Select HK Onyx BT on the device’s pairing list and enter pasword as 0000.The device will be paired to HK Onyx automatically. If pairing is successful,the Onyx’s Status LED will change to white.5. Control playback from your Bluetooth-capable device.6. You can change the name of the speaker for easyidentification using the H/ K Remote app.