© 2012 Harmonic Inc. 50 Electra 1000, Version 3.0, Rev MAppendix DBoot SequenceThis appendix describes the encoder boot sequence, including the messages that appear onthe local control panel display.D.1 Local Control Panel Display Messages during BootupMessages on the local control panel indicate progress during boot-up. During a successfulboot, many events occur so quickly you cannot see the messages. The following sectionsdescribe the messages that you can see during boot attempts.NOTE: During the boot sequence, do not press any key on the keypad.The following sequence describes the display on the vacuum fluorescent display (VFD) duringa successful startup: Power onVFD line 1 = Harmonic IncVFD line 2 = System Loading Begin loadingVFD line 1 = ElectraVFD line 2 = System Loading BootingVFD line 1 = ElectraVFD line 2 = Loading xxxxxxxx.elf FinishedVFD line 1 = ElectraVFD line 2 = Multichannel EncoderD.2 Other Local Control Panel Display MessagesThe local control panel displays messages for other types of restarts, including a system resetand loading new software.D.2.1 Resetting the EncoderWhen you reset the encoder from NMX, a message on the VFD shows that the encoder hasbeen reset. The encoder uses the boot file on the hard drive when you reset it. Reset from NMXVFD line 1 = Bye bye...VFD line 2 = After power cycleVFD line 1 = Harmonic IncVFD line 2 = System Loading Begin loading
