P-K SONIC® Gas Fired BoilerTechnical Service 1.877.728.5351Revised: June 2, 2017Released: June 2, 2017 HARSCO Industrial, Patterson-Kelley 2017All Rights Reserved.1004905978 P-K SONIC NURO Installation andOwners Manual (Rev F Jun-2017).docxPage 32.3 Compliance with CodesEach P-K SONIC® boiler with standard components complies with American National Standard/CSAStandard ANSI Z21.13/CSA 4.9, latest edition for Gas-Fired Low Pressure Steam and Hot WaterBoilers.The P-K SONIC® SC-1500, SC-2000, SC-3000 and SC-4000 heat exchangers are constructed andstamped in accordance with ASME Boiler and Pressure Vessel Code, Section IV for 160 psig maximumpressure and 210°F maximum temperature. Other codes or approvals which apply will be labeled onthe boiler.SC-1500 & SC-2000 SC-3000 & SC-4000Code of Construction(Boiler) ASME Section IV – “H”(Latest Edition)ASME Section IV – “H”(Latest Edition)Code of Construction(Economizer)ASME Section VIII – Div. 1 –“U” (Latest Edition)Maximum Allowable WorkingPressure 160 PSIGMaximum Allowable DesignTemperature 210° FHi-Limit Setpoint 200° FMaximum Setpoint 185° FInstallation of the boiler must conform to all the requirements of all national, state and local codesestablished by the authorities having jurisdiction or, in the absence of such requirements, to theNational Fuel Gas Code, ANSI Z223.1/NFPA 54 latest edition in the U.S. In Canada, the equipmentshall be installed in accordance with the current Installation Code for Gas Burning Appliances andEquipment, CAN/CSA-B.149, latest edition, and applicable Provincial Regulations for the class, whichshould be carefully followed in all cases. Authorities having jurisdiction should be consulted beforemaking any installation.Where required by local codes, the installation must conform to American Society of MechanicalEngineers Safety Code for Controls and Safety Devices for Automatically Fired Boilers (ASME CSD-1).In the Commonwealth of Massachusetts (a) this unit must be installed by a licensed pipe fitter/plumber,(b) field installed gas cocks must be “T” handle type, (c) piping of condensate shall conform to the StatePlumbing Code, and (d) refer to the Massachusetts Supplement for further details.
