Hartke KILO 1000WATT Owner's Manual

Also see for KILO: Owner's manual

Contents

Hartke KILO 1000WATT Owner's Manual Manual pdf 11 page image

Kilo • 1000 Watt Bass Amplifier11ENGLISHFRANÇAISDEUTSCHEESPAÑOLITALIANO124 83 615 16 197 910 11 12 17135 14 181. Voltage Selection Switch – This switch is used to set the Kilo operation voltage.Be sure to check that the switch is set correctly for your country.2. AC Inlet – Connect the supplied standard 3-pin “IEC” plug here. You should neverremove the ground pin of the AC plug.3. Fuse – This contains the fuse for your amplifier. Be sure to confirm and install theproperly rated fuse when replacing. Fuse ratings are 15 amp for 115 vac and 8amp for 230 vac.4. LEFT SPEAKER OUTPUTS – Use these outputs to connect speakers to the left am-plifier output. The amplifier provides both ¼” and Speakon® output connectors,wired in parallel. It is recommended to use the Speakon® jack whenever possible.The total impedance of the speakers connected to all of the jacks must not be lessthan 2 ohms.5. RIGHT SPEAKER OUTPUTS – Use these outputs to connect speakers to the rightamplifier output. The amplifier provides both ¼” and Speakon® output connectors,wired in parallel. It is recommended to use the Speakon® jack whenever possible.The total impedance of the speakers connected to all of the jacks must not be lessthan 2 ohms.6. MONO BRIDGE OUTPUTS – Connect a Speakon® connector cable here whenoperating in Bridge mode. The total impedance load of the speakers connected tothe output must not be less than 4 ohms.7. STEREO/MONO BRIDGE Switch – This switch is used to set the amplifier to oper-ate in either Stereo or Mono Bridge mode.8. MUTE+OVERDRIVE FOOTSWITCH – Connect a two-button footswitch, terminat-ing to a ¼” TRS connector (Tip = MUTE, Ring = OVERDRIVE) to this jack to controlthe MUTE and OVERDRIVE select switches. The front panel switch is disengagedwhen the footswitch is plugged in.Rear Panel