DID YOU RECEIVE THE CORRECT RESPONSE?If NO, continue to 002.If YES, proceed to 003.002If the Power Management feature is enabled, do the following:1. Start the Configuration/Setup Utility program. See “Setup Utility program” onpage 14.2. Select Power Management from the Configuration/Setup Utility programmenu.3. Select APM.4. Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (}) orRight Arrow (Æ) to change the setting.5. Select Automatic Hardware Power Management.6. Set Automatic Hardware Power Management to Disabled.7. If the problem persists, continue to 003.003Run the Diagnostic programs. If necessary, refer to “Diagnostics” on page 16.v If you receive an error, replace the part that the diagnostic program calls out orgo to ″Symptom-to-FRU Index″ on page Chapter 7, “Symptom-to-FRU index,”on page 47.v If the test stops and you cannot continue, replace the last device tested.4 Hardware Maintenance Manual Types 2292, 2273, 6043, 6343, 6349, 6350, 6790, 6791, 6792, 6793, 6794, 6795, 6823, 6825
