IBM 6343 Hardware Maintenance Manual

Also see for 2292: Hardware Maintenance Manual User guide Guías del usuario Guide d'utilisation Manual do utilizador

Contents

76 IBM : Hardware Maintenance Manual006-195-XXXDiskette interface Test aborted by user1. Information2. Re-start the test, if necessary006-196-XXXDiskette interface test halt, error thresholdexceeded1. Press F3 to review the log file2. Re-start the test to reset the log file006-197-XXXDiskette interface test warning1. If a component is called out, make sure itis connected and/or enabled2. Re-run test3. Component that is called out in warningstatement4. Component under test006-198-XXXDiskette interface test aborted1. If a component is called out, make sure itis connected and/or enabled2. Flash the system and re-test3. Go to the "Undetermined problems"section006-199-XXXDiskette interface test failed, cause unknown1. Go to the "Undetermined problems"section2. Flash the system and re-test3. Replace component under function test006-25X-XXXDiskette interface Error1. Diskette drive cable2. Diskette drive3. System board011-000-XXXSerial port Interface Test Passed1. No action011-001-XXXSerial port Presence1. Remove external serial device, if present2. Run setup, enable port3. System board011-002-XXX011-003-XXXSerial port Timeout/Parity error1. System board011-013-XXX011-014-XXXSerial port Control Signal/Loopback testfailure1. System board011-015-XXXSerial port External Loopback failure1. Wrap plug2. System board011-027-XXXSerial port Configuration/Setup error1. Run Setup, enable port2. Flash the system3. System board011-03X-XXX011-04X-XXXSerial port failure1. System board011-195-XXXSerial port Test aborted by user1. Information2. Re-start the test, if necessary011-196-XXXSerial port test halt, error threshold exceeded1. Press F3 to review the log file2. Re-start the test to reset the log fileDiagnostic Error Code FRU/Action