IBM 9040-MR9 Manual

Also see for 9040-MR9: Manual Manual User manual Manual Manual

Contents

(4x or all other provisioned mounting) locations with provided hardware only, prior to use. Loadobjects are designed to slide on/off smooth platforms without appreciable force, so take care notto push or lean. Keep riser tilt [adjustable angling platform] option flat at all times except for finalminor angle adjustment when needed.• Do not stand under overhanging load.• Do not use on uneven surface, incline or decline (major ramps).• Do not stack loads.• Do not operate while under the influence of drugs or alcohol.• Do not support ladder against LIFT TOOL (unless the specific allowance is provided for onefollowing qualified procedures for working at elevations with this TOOL).• Tipping hazard. Do not push or lean against load with raised platform.• Do not use as a personnel lifting platform or step. No riders.• Do not stand on any part of lift. Not a step.• Do not climb on mast.• Do not operate a damaged or malfunctioning LIFT TOOL machine.• Crush and pinch point hazard below platform. Only lower load in areas clear of personnel andobstructions. Keep hands and feet clear during operation.• No Forks. Never lift or move bare LIFT TOOL MACHINE with pallet truck, jack or fork lift.• Mast extends higher than platform. Be aware of ceiling height, cable trays, sprinklers, lights, andother overhead objects.• Do not leave LIFT TOOL machine unattended with an elevated load.• Watch and keep hands, fingers, and clothing clear when equipment is in motion.• Turn Winch with hand power only. If winch handle cannot be cranked easily with one hand, it isprobably over-loaded. Do not continue to turn winch past top or bottom of platform travel.Excessive unwinding will detach handle and damage cable. Always hold handle when lowering,unwinding. Always assure self that winch is holding load before releasing winch handle.• A winch accident could cause serious injury. Not for moving humans. Make certain clicking soundis heard as the equipment is being raised. Be sure winch is locked in position before releasinghandle. Read instruction page before operating this winch. Never allow winch to unwind freely.Freewheeling will cause uneven cable wrapping around winch drum, damage cable, and maycause serious injury.• This TOOL must be maintained correctly for IBM Service personnel to use it. IBM shall inspectcondition and verify maintenance history before operation. Personnel reserve the right not to useTOOL if inadequate. (C048)Power and cabling information for NEBS (Network Equipment-Building System) GR-1089-COREThe following comments apply to the IBM servers that have been designated as conforming to NEBS(Network Equipment-Building System) GR-1089-CORE:The equipment is suitable for installation in the following:• Network telecommunications facilities• Locations where the NEC (National Electrical Code) appliesThe intrabuilding ports of this equipment are suitable for connection to intrabuilding or unexposed wiringor cabling only. The intrabuilding ports of this equipment must not be metallically connected to theinterfaces that connect to the OSP (outside plant) or its wiring. These interfaces are designed for use asintrabuilding interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE) and require isolationfrom the exposed OSP cabling. The addition of primary protectors is not sufficient protection to connectthese interfaces metallically to OSP wiring.Note: All Ethernet cables must be shielded and grounded at both ends.xii Power Systems: Vital product data card for the 9040-MR9