IBM 9040-MR9 Manual

Also see for 9040-MR9: Manual Manual User manual Manual Manual

Contents

Figure 10. Connecting the power cords6. When the service processor comes up to the standby state (the power-on LED on the control panel isflashing slowly), continue to the next step.7. Turn off the identify LED. For instructions, see Deactivating an identify LED (www.ibm.com/support/knowledgecenter/POWER9/p9haj/p9haj_turn_off_identify_led.htm).8. Access the ASMI.If you are already connected to the ASMI, go to the next step.a) For instructions, see Accessing the ASMI without an HMC (www.ibm.com/support/knowledgecenter/POWER9/p9hby/connect_asmi.htm).b) Click Tasks.c) Click Operations > Launch Advanced System Management (ASM).9. In the ASMI navigation panel, expand Power/Restart Control > Power On/Off System. Clear Serverfirmware start policy and select Standby (User-Initiated). Then, click Save settings.10. Set the system identifiers and the activation codes for the Capacity on Demand (CoD) andVirtualization Engine technologies (VET):Note: To perform this operation, your authority level must be administrator or authorized serviceprovider.a) In the navigation area, expand System Configuration > Program Vital Product Data.Vital product data card for the 9040-MR9 13