IBM 9511-A Series User Manual

Contents

IBM 9511-A Series User Manual Manual pdf 11 page image

9DEUTSCH ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARRAuto Setup for DOSIf the monitor is in standbymode (STANDBY ON), itmay automatically turn off whileyou are waiting for it to warm up.If this happens, switch off themonitor and switch it on againafter a few seconds.1. Turn on the monitor first; then the PC.If the message CHECK SIGNAL CABLE is displayed, or if nothing isdisplayed check:• that the video interface cable is connected properly.• the correct video adapter card is installed.• the correct supported display mode is selected for your PC.If you are using PC-DOS/V, change to U.S. mode bytyping ‘CHEV US’ and pressingENTER at the commandprompt.2. Wait approximately 15 minutes, until the monitor warms up.3. Insert the diskette labelled ‘IBM Flat Panel Monitor Installation Disketteinto the diskette drive.You must use DOS whenyou run DOS Auto Setup.4. Display the command prompt screen of the DOS full-screen display.5. At the command prompt, type ‘A:’ and press ENTER.6. Type ‘TESTPATD’ and press ENTER.7. Select from the screen the number for the color or text mode you want tosetup.8. Select from the screen the number for the video mode you want tosetup.You may repeat this process for as many of the color and video modesas you need.The size and diversity ofthe dot pattern varies withthe screen resolution.9. When the dot pattern appears, press the OSD Enter button at thebottom of the monitor to display the initial OSD menu.If the screen flickers,repeat the setup severaltimes until the flicker isminimised, or adjust it manuallyby following Manual Setup onpage 12.10. Use an Arrow button ( or ) to select the IMAGE LOCK iconthen press the OSD Enter button to access the function.11. Using an Arrow button ( or ), select AUTOMATIC and press theOSD Enter button . This activates the A UTO S ETUP procedure, whichwill optimize the display settings with the provided dot-patterns.The screen will3d off several times and you may notice small changes tothe test pattern.12. When finished, the OSD main menu returns. Press the Exit buttonto exit from the OSD.13. Press the ESCAPE key to exit the test pattern program.14. Type ‘Exit’ at the command prompt to return to Windows.If you use other operating systems, perform the appropriate A UTO SETUP forthose systems, also: seeAuto Setup for Windows 3.1, Windows 95, Windows 98, Windows NT orWindows 2000 on page 10.T54A-E.book Page 9 Saturday, February 19, 2000 12:05 PM