232 IBM System Storage N series Hardware Guidec. Select the N series software that you want to download, and then select the Downloadview.d. Click Software Packages on the website that is shown and follow the onlineinstructions to download the software.3. Run the executable file, and then follow the instructions in the window.4. Reboot the Windows host when prompted.Installing the Host Utilities from the command lineYou can perform a quiet (unattended) installation of the Host Utilities by entering thecommands at a Windows command prompt. Enter the following command at a Windowscommand prompt:msiexec /i installer.msi /quietMULTIPATHING={0 | 1}[INSTALLDIR=inst_path]where: installer is the name of the .msi file for your processor architecture. MULTIPATHING specifies whether MPIO support is installed. Allowed values are 0 for no orand 1 for yes. inst_path is the path where the Host Utilities files are installed. The default path isC:\Program Files\IBM\Windows Host Utilities\.17.4.4 Host configuration settingsYou must collect some host configuration settings as part of the installation process. The HostUtilities installer modifies other host settings that are based on your installation choices.Fibre Channel and iSCSI identifiersThe storage system identifies hosts that are allowed to access LUNs. The hosts are identifiedbased on the Fibre Channel worldwide port names (WWPNs) or iSCSI initiator node name onthe host.Each Fibre Channel port has its own WWPN. A host has a single iSCSI node name for alliSCSI ports. You need these identifiers when you are manually creating initiator groups(igroups) on the storage system.The storage system also has WWPNs and an iSCSI node name, but you do not need them toconfigure the host.Recording the WWPNRecord the worldwide port names of all Fibre Channel ports that connect to the storagesystem. Each HBA port has its own WWPN. For a dual-port HBA, you must record twovalues; for a quad-port HBA, record four values.Tip: The Windows Host Utilities installer checks for required Windows hotfixes. If itdetects a missing hotfix, it displays an error. Download and install the requestedhotfixes, then restart the installer.