IBM NetVista Quick Reference

Also see for NetVista: Hardware Maintenance Manual Hardware Maintenance Manual Hardware maintenance guide Hardware Maintenance Manual Hardware maintenance guide

Contents

A digital device when the NIC is in use. The Class A digital device rating andcompliance notice are primarily because the inclusion of certain Class Aoptions or Class A NIC cables changes the overall rating of the computer toClass A.Cet ordinateur est enregistré comme un appareil numérique de classe B.Toutefois, lorsque la carte réseau qu’il contient est utilisée, il est considérécomme un appareil de classe A. Il a été déclaré de classe A dans l’avis deconformité car la présence de certaines options de classe A ou de câbles decarte réseau de classe A modifie ses caractérisques et le rend conforme auxnormes de la classe A.Class B noticesThese notices refer to machine types 2251, 2254, 2256, 2257, 2271, 2292, 6029,6058, 6059, 6336, 6337, 6339, 6341, 6342, 6343, 6346, 6347, 6348, 6349, 6350, 6568,6569, 6578, 6579, 6648, 6649, 6790, 6791, 6792, 6793, 6794, 6823, 6825, 6830, 6831,6832, 6833, 6840, 6841, 8301, 8302, 8303, 8304, 8305, 8306, 8307, 8308, 8309, 8310,8311, 8312, 8313, 8314, and 8315.Federal Communications Commission (FCC) statementNote: This equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses, and can radiate radiofrequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one or moreof the following measures:v Reorient or relocate the receiving antenna.v Increase the separation between the equipment and receiver.v Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.v Consult an IBM authorized dealer or service representative for help.Properly shielded and grounded cables and connectors must be used in orderto meet FCC emission limits. Proper cables and connectors are available fromIBM authorized dealers. IBM is not responsible for any radio or televisioninterference caused by using other than recommended cables and connectors orby unauthorized changes or modifications to this equipment. Unauthorizedchanges or modifications could void the user’s authority to operate theequipment.Appendix B. Notices 53