IBM P202 Operating Instructions Manual

Contents

IBM P202 Operating Instructions Manual Manual pdf 11 page image

6Getting StartedHorizontalFrequency*VerticalFrequency*Before adjusting• Connect the monitor and the computer, and turn them on.• Select “ LANG” in the MENU OSD, then select“ENGLISH” (see page 14).Adjusting the Picture Brightnessand ContrastOnce the setting is adjusted, it will be stored in memory forall input signals received.1 Press the ¨ (brightness) ./> or > (contrast) ?//buttons.The BRIGHTNESS/CONTRAST OSD appears.2 For brightness adjustmentPress the ¨./> buttons.> . . . for more brightness. . . . for less brightnessFor contrast adjustmentPress the >?// buttons./ . . . for more contrast? . . . for less contrastThe OSD automatically disappears after about 3 seconds.To reset, press the ? (reset) button while the OSD is on.The brightness and contrast are both reset to the factorysettings.* The horizontal and vertical frequencies for the received inputsignal appear in the BRIGHTNESS/CONTRAST OSD.Customizing Your MonitorBRIGHTNESS/CONTRAST26 2680.0kHz/ 75Hz5 Press the >?// buttons to select “1” or “2.”When “1” is selectedThe signal from the computer connected to the HD15connector is input to the monitor.When “2” is selectedThe signal from the computer connected to the 13W3connector is input to the monitor.The OPTION OSD automatically disappears after about 30seconds.To close the OSD, press the button again.For more information on using the OSD, see “Introducingthe On-screen Display System” on page 7.When you connect computers to both connectorsIf you restart the computer you want to view, or thatcomputer is in power saving mode, the monitor mayautomatically select the other connector‘s signal. This isbecause the monitor switches from the interrupted signal tothe constant signal. If this happens, manually select thedesired signal.