IBM Power System 9040-MR9 Manual

Also see for 9040-MR9: Manual Manual Manual User manual Manual

– For racks with a DC power distribution panel (PDP), connect the customer’s DC power sourceto the PDP. Ensure that the proper polarity is used when attaching the DC power and DC powerreturn wiring.• Connect any equipment that will be attached to this product to properly wired outlets.• When possible, use one hand only to connect or disconnect signal cables.• Never turn on any equipment when there is evidence of fire, water, or structural damage.• Do not attempt to switch on power to the machine until all possible unsafe conditions arecorrected.• Assume that an electrical safety hazard is present. Perform all continuity, grounding, and powerchecks specified during the subsystem installation procedures to ensure that the machine meetssafety requirements.• Do not continue with the inspection if any unsafe conditions are present.• Before you open the device covers, unless instructed otherwise in the installation andconfiguration procedures: Disconnect the attached AC power cords, turn off the applicablecircuit breakers located in the rack power distribution panel (PDP), and disconnect anytelecommunications systems, networks, and modems.DANGER:• Connect and disconnect cables as described in the following procedures when installing,moving, or opening covers on this product or attached devices.To Disconnect:1. Turn off everything (unless instructed otherwise).2. For AC power, remove the power cords from the outlets.3. For racks with a DC power distribution panel (PDP), turn off the circuit breakers located in thePDP and remove the power from the Customer's DC power source.4. Remove the signal cables from the connectors.5. Remove all cables from the devices.To Connect:1. Turn off everything (unless instructed otherwise).2. Attach all cables to the devices.3. Attach the signal cables to the connectors.4. For AC power, attach the power cords to the outlets.5. For racks with a DC power distribution panel (PDP), restore the power from the Customer'sDC power source and turn on the circuit breakers located in the PDP.6. Turn on the devices.Sharp edges, corners and joints may be present in and around the system. Use care whenhandling equipment to avoid cuts, scrapes and pinching. (D005)(R001 part 1 of 2):DANGER: Observe the following precautions when working on or around your IT rack system:• Heavy equipment–personal injury or equipment damage might result if mishandled.• Always lower the leveling pads on the rack cabinet.• Always install stabilizer brackets on the rack cabinet if provided, unless the earthquake option isto be installed..• To avoid hazardous conditions due to uneven mechanical loading, always install the heaviestdevices in the bottom of the rack cabinet. Always install servers and optional devices startingfrom the bottom of the rack cabinet.vi Power Systems: Disk drives or solid-state drives