IBM Power Systems 5887 Manual

Also see for 5887: Installing Removal and replacement procedures Installing

(L008)CAUTION: Hazardous moving parts nearby. (L008)All lasers are certified in the U.S. to conform to the requirements of DHHS 21 CFR Subchapter J for class 1laser products. Outside the U.S., they are certified to be in compliance with IEC 60825 as a class 1 laserproduct. Consult the label on each part for laser certification numbers and approval information.CAUTION: This product might contain one or more of the following devices: CD-ROM drive, DVD-ROM drive, DVD-RAM drive, or laser module, which are Class 1 laser products. Note the followinginformation:• Do not remove the covers. Removing the covers of the laser product could result in exposure tohazardous laser radiation. There are no serviceable parts inside the device.• Use of the controls or adjustments or performance of procedures other than those specifiedherein might result in hazardous radiation exposure.(C026)CAUTION: Data processing environments can contain equipment transmitting on system linkswith laser modules that operate at greater than Class 1 power levels. For this reason, never lookinto the end of an optical fiber cable or open receptacle. Although shining light into one end andlooking into the other end of a disconnected optical fiber to verify the continuity of optic fibers maynot injure the eye, this procedure is potentially dangerous. Therefore, verifying the continuity ofoptical fibers by shining light into one end and looking at the other end is not recommended. Toverify continuity of a fiber optic cable, use an optical light source and power meter. (C027)CAUTION: This product contains a Class 1M laser. Do not view directly with optical instruments.(C028)CAUTION: Some laser products contain an embedded Class 3A or Class 3B laser diode. Note thefollowing information:• Laser radiation when open.• Do not stare into the beam, do not view directly with optical instruments, and avoid directexposure to the beam. (C030)(C030)CAUTION: The battery contains lithium. To avoid possible explosion, do not burn or charge thebattery.Do Not:• Throw or immerse into water• Heat to more than 100 degrees C (212 degrees F)• Repair or disassembleExchange only with the IBM-approved part. Recycle or discard the battery as instructed by localregulations. In the United States, IBM has a process for the collection of this battery. Forinformation, call 1-800-426-4333. Have the IBM part number for the battery unit available whenyou call. (C003)CAUTION: Regarding IBM provided VENDOR LIFT TOOL:• Operation of LIFT TOOL by authorized personnel only.Safety notices xi