IBM Power Systems 5887 Manual

Also see for 5887: Installing Removal and replacement procedures Installing

About this taskTo install the disk drive enclosure into the rack, complete the following steps:Procedure1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is pluggedinto a ground jack or connected to an unpainted metal surface. If not, do so now.2. Remove the left side cover (A) and right side cover (B) to show the mounting brackets.3. Pinch the release to rotate the cover up and off from the chassis flange as shown in Figure 18 on page19.Figure 18. Removing the side covers4. Using two people, lift the enclosure and position it over the front of the rails.Attention: Two people are required to safely lift the enclosure. Using fewer than two people tolift the enclosure can result in injury.5. Slide the enclosure into the rack cabinet.Installing the 5887 disk drive enclosure or setting up a preinstalled 5887 disk drive enclosure 19