IBM System x3550 M4 Installation And User Manual

Also see for Redboks System x3550 M4: User guide Product guide Installation and service guide Product guide

Contents

IBM System x3550 M4 Installation And User Manual Manual pdf 100 page image

Attention:v Do not set down the heat sink after you remove the plastic cover.v Do not touch the thermal grease on the bottom of the heat sink after youremove the plastic cover. Touching the thermal grease will contaminate it.See “Thermal grease” for more information.a. Remove the plastic protective cover from the bottom of the heat sink.b. Position the heat sink over the microprocessor. The heat sink is keyed toassist with proper alignment.c. Align and place the heat sink on top of the microprocessor in the retentionbracket, thermal material side down.d. Press firmly on the heat sink.e. Rotate the heat sink retention module release lever to the closed positionand hook it underneath the lock tab.12. If you installed the second microprocessor, install the fourth and sixth fans (see“Installing a hot-swap fan assembly” on page 93).If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 101.Thermal greaseThe thermal grease must be replaced whenever the heat sink has been removedfrom the top of the microprocessor and is going to be reused or when debris isfound in the grease.84 IBM System x3550 M4 Type 7914: Installation and User’s Guide