IBM THINKCENTRE 8086 User Manual

Contents

Command Function&V1 Display Last Connection Statistics&W_ &W0 Stores the active profile as Profile 0&W1 Stores the active profile as Profile 1%E_ %E0 Disable auto-retrain%E1 Enable auto-retrain+MS? Displays the current Select Modulationsettings+MS=? Displays a list of supported Select Modulationoptions+MS=a,b,c,e,f Select modulation where: a=0, 1, 2, 3, 9, 10, 11,12, 56, 64, 69; b=0-1; c=300-56000; d=300-56000; e=0-1; and f=0-1. A, b, c, d, e, fdefault=12, 1, 300, 56000, 0, 0. Parameter ″a″specifies the modulation protocol desiredwhere: 0=V.21, 1=V.22, 2=V.22bis, 3=V.23,9=V.32, 10=V.32bis, 11=V.34,12=V.90,K56Flex,V.34......,56=K 56Flex,V.90,V.34......, 64=Bell 103, and 69=Bell 212.Parameter ″b″ specifies automode operationswhere: 0=automode disabled, 1= automodeenabled with V.8/V.32 Annex A. Parameter ″c″specifies the minimum connection data rate(300- 56000). Parameter ″d″ specifies themaximum connection rate (300-56000);Parameter ″e″ specifies the codec type (0=Law, and 1=A-Law). Parameter ″f″ specifies″robbed bit″ signaling detection (0=detectiondisabled 1=detection enabled)MNP/V.42/V.42bis/V.44 commandsCommand Function%C_ %C0 Disable MNP Class 5 and V.42bis data compression%C1 Enable MNP Class 5 data compression only%C2 Enable V.42bis data compression only%C3 Enable MNP Class 5 and V.42bis data compression&Q_ &Q0 Direct data link only (same as \N1)&Q5 V.42 data link with fallback options&Q6 Normal data link only (same as \N0)+DS44=0, 0 Disable V.44+DS44=3, 0 Enable V.44+DS44? Current values+DS44=? List of support values38 User Guide