IBM xSeries 300 Hardware Maintenance Manual

Also see for xSeries 300: Service guide Datorns förinstallerade program Vooraf geïnstalleerde software Tietoja ohjelmistosta Om programvaren

Contents

Turning on the serverTurning on the server refers to the act of plugging the power cord of your serverinto the power source and starting the operating system.Complete the following steps to turn on the server:1. Plug the power cord of your server into the power source.Note: Plugging the power cord into a power source may cause the server tostart automatically. This is an acceptable action.2. Wait 30 seconds, and then press the power control button on the front of theserver.Turning off the serverTurning off the server refers to the act of disconnecting the server from the powersource.Complete the following steps to turn off the server:1. Refer to your operating system documentation for the proper procedure to shutdown the operating system.Statement 5:CAUTION:The power control button on the device and the power switch on the powersupply do not turn off the electrical current supplied to the device. Thedevice also might have more than one power cord. To remove all electricalcurrent from the device, ensure that all power cords are disconnected fromthe power source.122. Press the power control button on the front of the server. This will put theserver in standby mode.3. Disconnect the server from the power source.Note: After you turn off the server, wait at least 5 seconds before you turn onthe server again.Chapter 2. General information 9