IBM xSeries 300 Hardware Maintenance Manual

Also see for xSeries 300: Service guide Datorns förinstallerade program Vooraf geïnstalleerde software Tietoja ohjelmistosta Om programvaren

Contents

Table 4. NDIS (Windows NT or Windows 2000) driver messages for the Ethernetcontroller (continued)Error code(hex)Description0x03 Explanation: Failed self-test. Action: Make sure a cable is attached to theEthernet connector.0x0D Explanation: Could not allocate enough memory for transmit queues.Action:1. From the Windows NT desktop, select Start → Control Panel →Networks → Adapters.2. Select your IBM Ethernet adapter from the list.3. Select Properties → Advanced.4. Lower the resource values that apply to the transmit queue.0x0E Explanation: Could not allocate enough memory for receive queue. Action:1. From the Windows NT desktop, select Start →Control Panel →Networks→Adapters.2. Select your IBM Ethernet adapter from the list.3. Select Properties →Advanced.4. Lower the resource values that apply to the receive queue.0x0F Explanation: Could not allocate enough memory for other structures.Action:1. From the Windows NT desktop, select Start → Control Panel →Networks → Adapters.2. Select your IBM Ethernet adapter from the list.3. Select Properties →Advanced.4. Lower the value for the resource named in the message.0x10 Explanation: Did not find any Ethernet controllers. Action: Using theConfiguration/Setup Utility program, make sure that Ethernet is enabled.0x11 Explanation: Multiple Ethernet controllers found, but none matched therequired ID. Action: Using the Configuration/Setup Utility program, makesure that Ethernet is enabled.0x13 Explanation: Did not find any Ethernet controllers that matched therequired subven/subdev. Action: Using the Configuration/Setup Utilityprogram, make sure that Ethernet is enabled.0x16 Explanation: Single adapter found, but multiple instances tried to load.Action: Using the Configuration/Setup Utility program, make sure thatEthernet is enabled, and that the slot containing the IBM xSeries 20010/100 Ethernet Adapter or the IBM 10/100 Etherjet PCI adapter isenabled.0x17 Explanation: Slot parameter not specified in the registry. Action: Removethe adapter driver and reinstall it.26 Hardware Maintenance Manual: xSeries 300