ICP DAS USA I-7000 Series User Manual

Also see for M-7000 series: User manual Quick start Quick start guide

M-7084 User Manual, Rev. A1.3 7PH-013-A13 211.10.2 INIT ModeWhen the module is powered on, with the rear slide switch setto the INIT position as shown in the figure below for moduleswith frame ground, or with the INIT* pin connected to theGND pin for modules without frame ground, the module is inINIT mode, (see Section A.1 for details), and thecommunication settings are as follows:1. Address: 002. Baud Rate: 9600 bps3. No checksum4. Protocol: DCONIf communication with the module is not possible, set themodule to the INIT mode and use the above settings tocommunicate with the module. To read the current settings,send the commands $AA2, (see Section 2.6), and $AAP, (seeSection 2.22). To set new settings, send the commands%AANNTTCCFF, (see Section 2.1) and $AAPN, (seeSection 2.23). The new communication settings will beeffective after the next power-on reset.