ICP DAS USA I-7000 Series User Manual

Also see for M-7000 series: User manual Quick start Quick start guide

M-7084 User Manual, Rev. A1.3 7PH-013-A13 29General Command SetsCommand Response Description Section%AANNTTCCFF !AA Sets the Module Configuration 2.1$AA2 !AANNTTCCFF Reads the Module Configuration 2.6$AA5 !AAS Reads the Reset Status 2.11$AAF !AA(Data) Reads the firmware Version 2.19$AAI !AAS Reads the INIT Status 2.20$AAM !AA(Data) Reads the Module Name 2.21$AAP !AASC Reads the communication protocol 2.22$AAPN !AA Sets the communication protocol 2.23~AAI !AA Software INIT 2.41~AAO(Name) !AA Sets the Module Name 2.42~AARD !AAVV Reads the Response Delay Time 2.43~AARDVV !AA Sets the Response Delay Time 2.44~AATnn !AA Sets the Software INIT Timeout 2.45Counter/Frequency Command SetsCommand Response Description Section#AA >(Data) Reads the Input Data of AllChannels 2.2#AAN >(Data) Reads the Input Data of theSpecified Channel 2.3$AA0N !AA(Data) Reads the Low Pass Filter Time ofthe Specified Channel 2.4$AA0N(Data) !AA Sets the Low Pass Filter Time of theSpecified Channel 2.5$AA3N !AA(Data) Reads the Maximum Counter Valueof the Specified Channel 2.7$AA3N(Data) !AA Sets the Maximum Counter Value ofthe Specified Channel 2.8$AA4 !AAVV Reads the Low Pass Filter ChannelMask 2.9$AA4VV !AA Sets the Low Pass Filter ChannelMask 2.10$AA5VV !AA Starts/Stop Counting 2.12$AA6 !AAVV Reads the Start/Stop CountingStatus 2.13