IDEAL Networks NaviTEK NT User Manual
Also see for NaviTEK NT: Quick reference guide
                              | |
Contents
| 
NaviTEK NT 153800 Iss 1User Guide Page 13Tests - GeneralIn either Cable or Ethernet mode, when you select the TESTS icon, the display will show therange of tests available.Fig 10 Tests Menu – Cable mode Fig 11 Tests menu – Ethernet modeTo select a test highlight its icon and press Enter. Each test has its own result screen. This isindicated by the test name being shown in the information bar. Press the soft key RUN (F1) tostart the test. The test will use the setup criteria currently stored for that test. The F1 soft keychanges to STOP, giving you the opportunity to abort the test.When you want to change the setup criteria before a test is run, press the soft key SETUP(F3). The display will show a screen where all variables for the test can be changed. Press thesoft key APPLY (F2) to save the changes and return to the result screen.Highlight the Tests icon and press ENTER to access the settings andpreferences listed below:Set the cable type and color scheme to suit the cable to be tested,crossover allowed y/n, and NVP. NVP is preset at 72% but can be customset anywhere in the range of 59 to 89% to suit the cable to be tested.Select from three tones. This avoids confusion when a second or thirdtester is being used on the same installation. Choose on which pin, or pinpair, to play the tone to achieve the best results.Set the target URL/Numerical address,Count (Number of times to repeat the Ping - 1 to 999999),Pause (Interval between successive Pings - 1 to 5 seconds),Length (Number of bytes in Ping frame payload - 8 to 1000 bytes).TESTS WIREMAPTONE GENAUTOTESTTESTS PING 4PING 6TROUTE 4TROUTE 6BLINKAUTOTEST |
Related manuals for IDEAL Networks NaviTEK NT
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine