IEI Technology AFL2-12A-D525 User Manual

Also see for AFL2-12A-D525 Series: User manual User manual

Contents

AFL2-12A-D525 Series Panel PCPage 28 Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,to configure the jumpers or plug in added peripheral devices, groundthemselves first and wear and anti-static wristband.4.3 Installation and Configuration StepsThe following installation steps must be followed.Step 1: Unpack the flat bezel panel PCStep 2: Install an HDDStep 3: Configure the systemStep 4: Connect peripheral devices to the bottom panel of the flat bezel panel PCStep 5: Mount the flat bezel panel PC Step 0:4.4 HDD InstallationWARNING:Over-tightening back cover screws will crack the plastic frame.Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).To install the HDD into the AFL2-12A-D525, please follow the steps below:Step 1: Remove two (2) retention screws from the HDD cover (Figure 4-1).