DRPC-100 Embedded SystemPage 115Step 12: Enable the Auto Recovery Function option (Advanced iEi Feature AutoRecovery Function).BIOS SETUP UTILITYMain Advanced PCIPNP Boot Security Chipset ExitiEi FeatureAuto Recovery Function [Enabled]Recover from PXE [Disabled] Select Screen Select ItemEnter Go to SubScreenF1 General HelpF10 Save and ExitESC Exitv02.61 ©Copyright 1985-2006, American Megatrends, Inc.Figure A-30: IEI FeatureStep 13: Save changes and restart the system. If the system encounters a Blue Screen ofDeath (BSoD) or a hang for around 10 minutes, it will automatically restore fromthe factory default image. Step 0:A.4 Setup Procedure for LinuxThe initial setup procedures for a Linux system are mostly the same with the procedure forMicrosoft Windows. Please follow the steps below to setup the recovery tool for Linux OS.Step 1: Hardware and BIOS setup. Refer to Section 78 5H785H A.2.1.Step 2: Install Linux operating system. Make sure to install GRUB (v0.97 or earlier)MBR type and Ext3 partition type. Leave enough space on the hard drive tocreate the recover partition later.
