ECW-281B-BTi Embedded SystemPage 614.3.8 IDE ConfigurationUse the IDE Configuration menu (5BIOS Menu 13) to change and/or set the configurationof the SATA devices installed in the system.Aptio Setup Utility – Copyright (C) 2013 American Megatrends, Inc.AdvancedIDE ConfigurationSATA Mode [AHCI Mode]Serial-ATA Port 1 [Enabled]SATA Port1 HotPlug [Disabled]Serial-ATA Port 0 [Enabled]SATA Port0 HotPlug [Disabled]SATA1 PortNot PresentSATA2 PortNot PresentSelect IDE/AHCI---------------------: Select Screen : Select ItemEnter: Select+/-: Change Opt.F1: General HelpF2: Previous ValuesF3: Optimized DefaultsF4: Save & ExitESC: ExitVersion 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.BIOS Menu 13: IDE Configuration SATA Mode [AHCI Mode]Use the SATA Mode option to determine how SATA devices operate. IDE Mode Configures SATA devices as normal IDE device. AHCI Mode D EFAULT Configures SATA devices as AHCI device. Serial-ATA Port 1/0 [Enabled]Use the Serial-ATA Port 1/0 option to configure the SATA controller(s). Enabled D EFAULT Enables the on-board SATA controller(s). Disabled Disables the on-board SATA controller(s).
