IVS-300 Embedded SystemPage 584.3.6 IDE ConfigurationUse the IDE Configuration menu (3BIOS Menu 10) to change and/or set the configurationof the SATA devices installed in the system.Aptio Setup Utility – Copyright (C) 2016 American Megatrends, Inc.AdvancedIDE ConfigurationSerial-ATA (SATA) [Enabled]SATA Mode [IDE Mode]SATA Port1 EmptySATA Port2 EmptyEnable / Disable Serial ATA---------------------: Select Screen : Select ItemEnter: Select+/-: Change Opt.F1: General HelpF2: Previous ValuesF3: Optimized DefaultsF4: Save & ExitESC: ExitVersion 2.17.1245. Copyright (C) 2016 American Megatrends, Inc.BIOS Menu 10: IDE Configuration Serial-ATA (SATA) [Enabled]Use the Serial-ATA (SATA) option to configure the SATA controller. Enabled D EFAULT Enables the on-board SATA controller. Disabled Disables the on-board SATA controller. SATA Mode [IDE Mode]Use the SATA Mode option to configure SATA devices as normal IDE or AHCI devices. IDE Mode D EFAULT Configures SATA devices as normal IDE device. AHCI Mode Configures SATA devices as AHCI device.
