IEI Technology NANO-945GSE2 User Manual

Also see for NANO-945GSE2: Quick installation guide

Contents

IEI Technology NANO-945GSE2 User Manual Manual pdf 75 page image

NANO-945GSE2Page 61Figure 4-13: SATA Power Drive Connection4.7.4 Single RS-232 Cable (w/o Bracket)The single RS-232 cable consists of one serial port connector attached to a serialcommunications cable that is then attached to a D-sub 9 male connector. To install thesingle RS-232 cable, please follow the steps below.Step 1: Locate the connector. The location of the RS-232 connector is shown inChapter 4.Step 2: Align the connectors. Correctly align pin 1 on the cable connector with pin 1 onthe NANO-945GSE2 serial port connector.Step 3: Insert the cable connectors. Once the cable connector is properly aligned withthe serial port connector on the NANO-945GSE2, connect the cable connectorto the on-board connector. See Figure 4-14.