WAFER-LX MotherboardPage 64o When installing or configuring the motherboard, place it on an antistaticpad. This helps to prevent potential ESD damage. Turn off all power to the WAFER-LX:o When working with the motherboard, make sure that it is disconnectedfrom all power supplies and that no electricity is being fed into the system.Before and during the installation of the WAFER-LX DO NOT do the following: DO NOT remove any of the stickers on the PCB board. These stickers arerequired for warranty validation. DO NOT use the product before verifying all the cables and power connectorsare properly connected. DO NOT allow screws to come in contact with the PCB circuit, connector pins,or its components.5.3 UnpackingNOTE:If any of the items listed below are missing when the WAFER-LX isunpacked, do not proceed with the installation and contact theWAFER-LX reseller or vendor.5.3.1 Unpacking PrecautionsBefore installing the WAFER-LX, unpack the motherboard. Some components onWAFER-LX are very sensitive to static electricity and can be damaged by a sudden rushof power. To protect it from being damaged, follow these precautions: The user should ground them self to remove any static charge beforetouching the WAFER-LX. To do so wear a grounded wrist strap at all times orfrequently touch any conducting materials that is connected to the ground. Handle the WAFER-LX by its edges. Do not touch the IC chips, leads orcircuitry if not necessary.
