IFM Electronic CR0403 Programming Manual

Also see for CR0403: Installation instructions

Contents

IFM Electronic CR0403 Programming Manual Manual pdf 35 page image

35ifm Programming Manual ecomatmobile BasicController (CR0403) Runtime System V03.02 2015-04-01System description Software description>3.4.3 Operating states 1075After power on the ecomatmobile device can be in one of five possible operating states:• BOOTLOADER• INIT• STOP• RUN• SYSTEM STOP>INIT state (Reset) 1076Premise: a valid runtime system is installed.This state is passed through after every power on reset:> The runtime system is initialised.> Various checks are carried out, e.g. waiting for correctly power supply voltage.> This temporary state is replaced by the RUN or STOP state.> The LED lights orange.Change out of this state possible into one of the following states:• RUN• STOP>STOP state 8288A transition into this state is possible in the following cases:• from the INIT state if no application program is loaded.• From the RUN state if the following condition is met:• The STOP command is sent via the CODESYS interface.In the STOP state:> The outputs of the device are switched off.> Processing of the application program is stopped.> The LED lights green.A transition from this state into one of the following states is possible:• RUN• ERROR• FATAL ERROR• INIT (after power-on-reset)