IHI Shibaura G-FLOW22 User Manual
                                                   | |
Contents
| 
41.BJOUFOBODF■ Removing/installing the bedknife support● Remove the reel unit from the mower. (Refer to "Remov-ing/installing the reel unit" on page 40.)〈Removing the bedknife support〉1. Place the reel unit on the working table.2. Turn the bedknife adjustment handles (right and left)half in the counterclockwise direction to open the gapbetween the bedknife and the blades.3. Loosen and remove the three M8 flange nuts holdingthe cutter cover, and then remove the cutter cover alongwith the baffle plate.4. Pressing down the adjustment bolts (right and left) onthe collar of the bedknife support with a spanner, loos-en the spring adjustment nuts (until they touch the ad-justment bolt heads)● Check that the bedknife support moves up and down.5. Loosen and remove the support bolts (right and left)on the bedknife support.● Be sure to hold the bedknife support when removing thesupport bolts.6. Loosen and remove the two M6 flush bolts holding oneof the collar of the bedknife support (right or left) toseparate it from the bedknife support.7. Pull off the bedknife support from between the bladeand the rear roller (underside) of the reel unit.● Install the bedknife support in the reverse order of removing.Warning● Be sure to stop the engine before removing/in-stalling the bedknife support.● Wear thick work gloves or leather gloves whenremoving/installing the bedknife support. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine