IKA HB 10 Operating Instructions Manual

Also see for HB 10: Operating instructions Operating instructions Operating instructions

Contents

IKA HB 10 Operating Instructions Manual Manual pdf 15 page image

15Error messageAny malfunctions during operation will be identified by an error message on the display (D), see fig. 5.Proceed as follows in such cases: Switch off device using the main switch (B) Carry out corrective measures Restart deviceError message Cause Effect CorrectionE 2 - In remote operation (PC), no communication Heating off - Switch off the devicebetween RV 10 and HB 10 - Clean the IR interface or- IR connection to RV 10 disconnected remove objects from around the IRinterface- Switch on the deviceE 3 - Temperature inside the device is too high Heating off - Switch off the device- Let the device cool down- Switch on the deviceE 9 - Fault in storing the safety circuit set Heating off - Switch off the devicetemperatures - Let the device cool down- Memory chip (EPROM) defective - Switch on the deviceE 21 - Safety relay does not open Heating off - Switch off the device and switch on againE 23 - Adjustable safety circuit defective Heating off - Switch off the device- Let the device cool down- Switch on the deviceE 24 - Set safety temperature exceeded Heating off - Switch off the device and switch on again- Let the device cool down- Switch on the device- Check the safety temperaturesettingE 25 - The heater control circuit switch (TRIAC) is Heating off - Switch off the device and switch on againfaulty. The heater or the supply line isdisconnected.E 26 - Dry running Heating off - Let the device cool down- Fill up the tempering medium- Switch off the device and switch on againE 27 - Error in calibration Heating off - Switch off the device and switch on againE 28 - Breakage of the controller sensor Heating off - Switch off the device and switch on againE 29 - Short-circuit in the safety sensor Heating off - Switch off the device and switch on againE 30 - Short-circuit in the controller sensor Heating off - Switch off the device and switch on againE 31 - Breakage of the safety sensor Heating off - Switch off the device and switch on againE 32 - Temperature deviation is too big Heating off - Switch off the device and switch on againIf the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:- contact the IKA® service department,- send the device for repair, including a short description of the fault.HB 10.1 Spray guardAccessoriesHB 10.2 Cover (incl. spray guard)