IKA MS 1 Operating Instructions Manual

Contents

With the purchase of this device, you have acquired a high-quality product.The speed-controlled motor allows for infinity speed adjustmentin the range from 0/200 to 2500 rpm. Electronic motorcontrol holds the set speed constant even if the weight of thematerial on the surface increases.The shaker MS 1 und MS 2 are suitable for continuous operation.The casing may heat up when the apliance is in use for a prolon-ged time.The various attachments can be changed easily by pulling them upoff the receptacle on the appliance. Ensure that the attachment ispositioned correctly when fitting. see spare parts diagramMS 1 and MS 2, p. 22.Check whether the voltage specified on the type plate matchesthe mains voltage available. The power socket used must beearthed (protective earth conductor contact). If these conditionsare met, the device is ready to operate after plugging in themains plug. If these procedures are not followed, safe operationcannot be guaranteed and/or the equipment may be damaged.Observe the ambient conditions (temperature, humidity, etc.)listed under “Technical Data”.Switching on and adjustment of speedThe rocker switch (A) for switching on the shaker is on the left ofthe appliance.The appliance is switched off in the centre position ”off”.The knob (B) for setting the speed is on the front of the applian-ce in the centre. The speed can be continuously adjusted within arange of 200 to 2500 rpm.The shaker cannot be set below 200 rpm as it will be at a standstill.When cold, the lowest possible speed may be slightly higher.Adjustment of the operation modeTouch operation modeTo set the shaker to touch mode, set the rocker switch (A) to”Touch”. You must also release the rocker catch (D) on shakerMS 1: select the ”Touch” position. If the speed is set to 200 rpmor higher, you can start the shaking process by pressing on theattachment.Continuous operation modeTo set the shaker to continuous mode, set the rocker switch (A) to”On”. If the speed is set to 200 rpm or higher, the appliance willbegin to shake immediately. When the knob (B) is at the left stop,the shaker will initially stand still, allowing you to set the requiredspeed. You can also set the rocker catch (D) for shaker MS 1:select the ”platform” position.11MS1/2 122004General informationCommissioningKnob (B)Rocker switch (A)Rocker catch (D),only MS 1Standard attachment (C)Fig. 2: Operating elements