IKA MS 1 Operating Instructions Manual

Contents

13MS1/2 122004Max. speed Touch- Continuous[rpm] operation mode operation modeMS 1.1 2500 yes noStandard attachmentMS 1.2 1400 yes yesOne-hand attachmentMS 1.3 1400 no yesTest tube attachment withone-hand insertMS 1.4 800 no yesMicrotiter plate attachmentIf the shaker is screwed down (i.e. built into a system), pleasenote that dynamic forces can be generated during operation as aresult of unfavourable loading and a poor centre of gravity positi-on. This could cause the surrounding area to vibrate or induceuncontrollable vibrations in the table. If you notice that the appli-ance is not running smoothly, reduce the speed until it runs smoo-thly again.The shaker MS 1 and MS 2 are maintenance-free. It is sub-ject only to the natural wear and tear of components and their sta-tistical failure rate.When ordering spare parts, please give the manufacturingnumber shown on the type plate, the machine type and thename of the spare part.Please send in equipment for repair only after it has been cleanedand is free from any materials which may constitute a healthhazard. Please tell us if you have used any materials which aredangerous or which may constitute a health hazard.Use only cleansing agents which have been approved by IKAto clean IKA devices.To remove use:Dyes isopropyl alcoholConstruction materials water containing tenside/ isopropyl alcoholCosmetics water containing tenside/ isopropyl alcoholFoodstuffs water containing tensideFuels water containing tensideFor materials which are not listed, please request information fromIKA. Wear the proper protective gloves during cleaning of thedevices. Electrical devices may not be placed in the cleansingagent for the purpose of cleaning.Before using another than the recommended method for cleaningor decontamination, the user must ascertain with the manufactu-rer that this method does not destroy the instrument.Designation Description Id-No. MS 1 MS 2MS 1.1 For small tubes and vessels L001260 X XStandard attachment upto diameter 30 mmMS 1.2 Consisting of MS 1.3 L001900 X XOne-hand attachment and MS 1.21MS 1.3 Attachment for inserts L001490 X XTest tube attachment MS 1.21, MS 1.31, MS 1.32,MS 1.33, MS 1.34MS 1.4 For microtiter plate L001280 X -Microtiter plate attachmentMS 1.21 For vessels with flat L001540 X XOne-hand insert baseMS 1.31 For 14 vessels L001840 X XTest tube insert with diameter 8 mmMS 1.32 For 6 vessels L001850 X XTest tube insert with diameter 10 mmMS 1.33 For 4 vessels L001860 X XTest tube insert with diameter 15 mmMS 1.34 For any number of L001830 X XTest tube insert bore holesMaintenance and cleaningAccessories