4. Use the shuttle in less than 5 seconds toset the core temperature.5. Set the heating function and, ifnecessary, the oven temperature.The oven calculates an approximate endtime. The end time is different for thedifferent quantities of the food, the set oventemperatures (minimum 120 °C) and theoperating modes. The oven calculates theend time in approximately 30 minutes.6. To change the core temperature, press.When the meat is at the set coretemperature, a signal sounds. The oventurns off automatically.7. Press any symbol to stop the signal.8. Remove the core temperature sensorplug from the socket and remove themeat from the oven.9. Press to turn off the oven.Warning! The core temperaturesensor is hot. There is a risk ofburns. Be careful when youremove the tip and the plug ofthe core temperature sensor.Using the telescopic runnersKeep the installation instructionsfor the telescopic runners forfuture use.With telescopic runners you can put in andremove wire shelves and trays easily.Caution! Do not clean thetelescopic runners in thedishwasher. Do not lubricate thetelescopic runners.1°CPull out the rightand left handtelescopic runners.2°CPut the wire shelf onthe telescopicrunners andcarefully push theminto the oven.Make sure you push back the telescopicrunners fully in the oven before you closethe oven door.Warning! Refer to "Productdescription" chapter.Additional functionsFavouritesYou can save your favourite settings, suchas duration, temperature or heatingfunction. They are available in the menu:Favourites. You can save 20 programmes.Saving a programme1. Turn on the oven.2. Set a heating function or an automaticprogramme.3. Press again and again until thedisplay shows: SAVE.4. Press to confirm.The display shows the first free memoryposition.5. Press to confirm.6. Enter the name of the programme.The first letter flashes.7. Use the shuttle to change the letter.8. Press .The next letter flashes.ENGLISH 22