2. Keep the knob pushed for about 5 sec; thiswill allow thermocouple to heat up, and thesafety device to switch off, otherwise thegas supply would be interrupted.3. After the flame is regular, adjust it as pre-ferred.If after a few attempts the burner does notignite, check that the crown and its capare in correct positions.123451 Burner cap2 Burner crown3 Ignition candle4 Injector5 ThermocoupleWarning! Do not keep control knobpressed for more than 15 seconds.If the burner does not light after 15 seconds,release the control knob, turn it into off positionand wait for at least 1 minute before trying tolight the burner again.Important! In the absence of electricity Youcan ignite the burner without electrical device;in this case approach the burner with a flame,push the relevant knob down and turn itcounter-clockwise to maximum gas releaseposition.Warning! Maintain extreme cautionwhen using open fire in kitchenenvironment. Manufacturer decline anyresponsibility in case misuse of the flame.If the burner accidentally goes out, turnthe control knob to the off position andwait for at least 1 minute before trying to lightit again.When switching on the mains, after in-stallation or a power cut, it is quite normalfor the spark generator to be activated auto-matically.Turning the burner offTo put the flame out, turn the knob to the sym-bol .Warning! Always turn the flame down orswitch it off before removing the pans ofthe burner.Helpful hints and tipsEnergy savings• If possible, always place lids on the pans.• As soon as liquid starts boiling, turn downthe flame to barley keep the liquid simmer-ing.Use pots and pans with bottom fitting the sizeof burner used.Burner minimum diam-eter of pots andpansmaximum di-ameter potsand pansRapid 180 mm 260 mmSemi-rapid120 mm 220 mmAuxili-ary80 mm 160 mmENGLISH 18