Gas connectionWarning! Refer to Safetychapters.Caution! Information forauthorised installer only.Connection to main pipeWarning! This appliance is notconnected to a combustionproducts evacuation device.Before you proceed with theinstallation, make sure that thelocal distribution conditions,nature of the gas and gaspressure, and the adjustment ofthe appliance are compatible.The installation must be compliant with thecurrent local gas fitting regulations and withAS/NZS 5601.1 Gas Installations Part 1:General Installations, and AS/NZS 5601.2Gas Installations Part 2: LP Gas installationsin caravans and boats for non-propulsivepurposes, or the relevant installation codefor gas appliances in your country.Complying with the local regulations, theconnection of the cooktop to the gas pipenetwork or gas cylinder must be made bymeans of a rigid copper or steel pipe withfittings, or by means of a continuous surfacestainless steel hose.If there is a problem with thepipe, do not repair it yourself.Contact the local After SalesService Provider. Refer to theGuarantee chapter.The connection must be installed correctlyand fixed into the hob connection pipe.Otherwise, gas may leak from theconnection pipe.This appliance is supplied for usewith Natural Gas. However, itcan be converted for use withLPG using the installation kitincluded.Make sure that the gas supplypressure obeys therecommended values. The nut atthe end of the shaft connects tothe R 1/2" parallel thread on theelbow union. The connection issealed using the supplied sealingwasher.A B CA. End of shaft with nutB. Washer supplied with the applianceC. Elbow supplied with the applianceWarning! When you finish theinstallation, check the sealingand pipe fixing. To check theinstallation, use soapy water. Donot use the flame.Supply pipe sizingThe total hourly gas consumption for theappliance is shown on the data label. Therequired supply pressure (i.e. at inlet toappliance regulator) for each gas type isshown on the data label, refer to theENGLISH 18