IKEA TYDLIG Instruction Manual

Contents

IKEA TYDLIG Instruction Manual Manual pdf 12 page image

InstallationManufacturer is not responsible for any in-jury to persons and pets or damage toproperty caused by failure to comply fol-lowing requirements.Caution! To proceed with theinstallation refer to the assemblyinstructions.Warning! Installation process mustfollow the laws, ordinances, directivesand standards (electrical safety rules andregulations, proper recycling in accordancewith the regulations, etc.) in force in thecountry of use!Warning! The appliance must beearthed!Warning! Risk of injury from electricalcurrent.• The electrical mains terminal is live.• Make electrical mains terminal free ofvoltage.• Loose and inappropriate plug and socketconnections can make the terminal over-heat.• Have the clamping connections correctlyinstalled.• Use strain relief clamp on cable.• Follow the connection diagram (it is loca-ted on the underneath surface of thecasting of the hob).Important! You must observe the minimumdistances to other appliances and furniturecabinets or other units according toAssembly Instruction.If there is no oven beneath the hob insert adividing panel at a minimum distance of 20mm from the bottom of the hob.Do not use silicon sealant between the ap-pliance and the worktop. Avoid installingthe appliance next to doors and under win-dows as hot cookware may be knocked offthe rings when doors and windows areopened.Only an authorized service engineer can in-stall, connect or repair this appliance. Useonly original spare parts.Electrical connectionBefore connecting, check that the nominalvoltage of the appliance stated on the rat-ing plate, corresponds to the available sup-ply voltage. Also, check the power rating ofthe appliance and ensure that the wire issuitably sized to suit the appliance powerrating (refer to the Technical data chapter).The rating plate is located on the lower cas-ing of the hob.The appliance is not provided with mainscable. Buy the right one from specializeddealer. Single-phase or two-phase connec-tion requires the mains cable of type H05BB-F/H05V2V2-F Tmax 90°C (equal orhigher).The appliance works perfectly on AC 230 V,AC220V~ or AC240V~ 50Hz electrical net-work.You must have the means for disconnectionincorporated in the fixed wiring. Have theappliance connected to the mains using adevice that allows the appliance to be dis-connected from the mains at all poles with acontact opening width of at least 3 mm, eg.automatic line protecting cut-out, earthleakage trips or fuse.You must have the connection and the con-necting links carried out as shown in theconnection diagram (it is located on the un-derneath surface of the casting of the hob).The earth lead is connected to terminalmarked with the symbol and must belonger than leads carrying electric current.Tighten the terminal screws securely! Finally,secure the connecting cable with the mainscable cleat and the covering closed bypressing firmly (lock into place).Warning! Once connected to themains supply check that all cookingzones are ready for use by briefly settingeach to maximum power.ENGLISH 12