1Open the door fully.2Lift and turn the lev-ers on the two hing-es.345°Close the oven doorto the first open po-sition (approx. 45°).Then pull forwardand remove it fromits seat.4Hold the door stripon the upper side ofthe oven door onboth sides andpress this inwards inorder to loosen theseal. Then pull thedoor strip upwardsand off.5Hold the glass pan-el on their upperside and it up andout of its retainer.Clean the glass panel with water and soap.Dry the glass panel carefully.Installing the glass panel and the doorWhen the cleaning is completed, install theglass panel and the oven door.Inserting the panel and the door:1. Slide the glass door panel into the re-tainer from above at an angle and thenlower the panel.The screen-printing zone must face theinner side of the door. Make sure thatafter the installation the surface of theglass panel frame on the screen-printingzones is not rough when you touch it.2. Hold the door strip on both sides, alignit with the inner edge of the door andpress the door strip into the upper edgeof the door.3. Open the door as far as it will go.4. Fold the clamp levers on both doorhinges down into their original position.5. Close the oven door.What to do if…Warning! Refer to the Safety chapters.Problem Possible cause RemedyThe oven does not heat up. The appliance is deactiva-ted.Activate the appliance.The oven does not heat up. The clock is not set. Set the clock.ENGLISH 16