Icom IC-7610 Reference Manual

Also see for IC-7610: Basic Manual Reference guide Advanced manual Service manual

Contents

Icom IC-7610 Reference Manual Manual pdf 8 page image

8■ Usable control commandsD Command descriptionCommandNumberSubcommandNumberData Command Function07 C2 00/01 Send/read the dualwatch setting(00=OFF, 01=ON)D2 00/01 Send/read the band selection(00=Main, 01=Sub)0F 00/01 Send/read the split setting(00=Split OFF, 01=Split ON)11 @9 00, 03 ~ 45 Send/read the Attenuator( 00=ATT OFF, 03=Minimum ~ 45=Maximum (3 dB step))12 @9 See p.9 Send/read the antenna14 02 @9 0000 ~ 0255 Send/read the RF Gain(0000=Minimum, 0255=Maximum) (BCD value)16* 02 @9 00/01/02 Send/read the PRE-AMP setting(00=OFF, 01=P.AMP1 ON, 02=P.AMP2 ON)4E @9 00/01 Set the DIGI-SEL function(00=OFF, 01=ON)65 @9 00/01 Send/read the IP+ function status(00=OFF, 01=ON)1A 0A* @9 00/01 Read the OVF indicator status(00=OFF, 01=ON)0B 00/01/02 Send/read the I/Q data output setting(00=OFF, 01=Main band I/Q output, 02=Sub band I/Q output)1C 00 00/01 Ttransceiver's status(00=RX, 01=TX)02 00/01 Transmit frequency monitor (XFC)(00=OFF, 01=ON)25 See p.9 Send/read the Main or Sub band frequency26 See p.10 Set the operating mode and filter setting29 00 or 01+SupportedcommendsSee p.11Regardless of active/inactive of the Main or Sub band, you candirectly specify theMain or Sub band, and send/read the supported commandsettings.(00=Main band, 01=Sub band)Commands other than listed above cannot be used with the [USB 2] port.*(Asterisk) Read only data@9 Regardless of active/inactive the Main or Sub band, you can directly specify the Main or Sub band, and send/read thesupported command settings. See page 11 for details.I/Q SIGNAL