Icom IC-A220 Instruction Manual

Also see for IC-A220: Service manual Installation guide Instruction manual Installation manual Installation guide

42BASIC OPERATION0102General description■The flow chart below shows the basic operating procedures.You need to set the frequency, activate the frequency, andreceive or transmit.There are two ways to set the frequency. Refer to page 5 and6 for details.• Set the frequency normally • Set the frequency directlySet the frequency normallySet the desired frequency which will be used for the next op-erating frequency in the standby frequency display. Then ex-change the active frequency for the standby frequency.Set the frequency directlyYou can directly enter the desired frequency.Refer to ‘Directly setting the frequency.‘TIP: For quick frequency setting, you can enter often-usedfrequencies into memory channels. Refer to “MEMORY OP-ERATION” for details. (pp. 7–13)When you recall a memory channel, the previous standbyfrequency is erased.Set the standby frequency.Activate the frequency.Enter the direct frequencysetting mode.Set the operating frequency.Receive/transmit