Icom IC-A24E Instruction Manual

Also see for IC-A24E: Service manual Service manual Instruction manual Instruction manual

NOTE: When programming the memory name to the pre-programmed memory channel do the following.q Follow the same steps as in “Transferring memory con-tents” (see p. 12).w Follow steps w–y in “Programming memory names”(see left column).Clearing the memory contents■Unwanted memory channels can be cleared.q Select the memory channel to be cleared.w Push , then hold down [CLR•DEL] for 1 second.• “-- -- -- -- -- --” appears momentarily, then the next selectablechannel appears.144 MEMORY OPERATIONMemory names■Programming memory namesïThe memory channel can display a 6-character name in-stead of the programmed frequency.q In the frequency mode, rotate [DIAL] to select the desiredfrequency.w Push , then push [MR•MW] to program the contentsinto the selected memory channel.e Rotate [DIAL] to select the desired memory channel to beprogrammed.• Push , then push [0•BANK], and rotate [DIAL] to select theBANK number, if desired. Push [CLR•DEL] to exit the BANK se-lection mode.r Push [MR•MW] to enter the memory name programmingmode.• “-- -- -- -- -- -- ” appears on the display.t Push the appropriate digit key several times to select thedesired character, as listed to the right.• To erase a character, overwrite with a space (displayed as _).• To move the cursor forwards or backwards, use [DIAL].y Push [ENT] to program the name.• The memory name stops flashing.• When no name is programmed, the display shows the operat-ing frequency.• To clear the entered memory names, push [CLR•DEL] beforepushing [ENT].Key Character Key Character Key Character1 1, Q, Z 2 2, A, B, C 3 3, D, E, F4 4, G, H, I 5 5, J, K, L 6 6, M, N, O7 7, P, R, S 8 8, T, U, V 9 9, W, X, YENT Program 0 0, space, -