5 NXDN™ OPERATION5-8Previous viewD Transmitting a Call Alert callA Call Alert call enables you to notify another userwho may be away from the transceiver that you wantto talk�1� Push [Digital Button] to enter the Applicationselection mode�• According to the current call type, “INDIV” (Individualcall) or “GROUP” (Group call) is briefly displayed, andthen “VOICE” is displayed�L If you want to change the call type, hold down [DigitalButton] for 1 second in the Standby mode�2� Push [CH Up] or [CH Down] to select“CALLALRT,” and then push [Digital Button]�3� Push [CH Up] or [CH Down] to select an Individualstation or a Group�4� Push [PTT] to transmit a Call Alert call�• “CA OK” is displayed when an acknowledgment isreceived from the targeted station�• “CA FAIL ” is displayed if an acknowledgment is notreceived from the targeted station�TIP:Hold down [Call Alert] for 1 second to transmit theCall Alert call�Transmitting a callD Transmitting an Emergency callAn NXDN Emergency call can be transmitted inthe same way as the 2-Tone, 5-Tone, or MDC 1200signaling operation� See “Emergency call” for details�(pp� 3-3 ~ 3-6)D Transmitting Position dataWhen the GPS function is ON, and the optionalHM-171GPW gps speaker microphone receivesPosition data, the longitude and latitude data can beautomatically transmitted:• When a GPS request status message is received�• At the preset interval�L Set the Auto to “Enable�”L Set the Interval Timer [mm:ss]�• After sending a voice message�L Set the Send with Login and Send with Logoff to“Enable�”• After sending a Status Message�L Set the Send with Status Call to “Enable�”• After sending a Call Alert�L Set the Send with Call Alert to “Enable�”• After sending an Emergency call�L Set the Send with Emergency to “Enable�”NOTE: To transmit position data, the settings aboveare required using the CS-F2100D programmingsoftware.(GPS > Setting)