243 BIIS OPERATION Stun functionWhen the specified ID, set as a killer ID, is received, the stunfunction is activated.When the killer ID is received, the transceiver switches to thepassword required condition. Entering of the password via thekeypad is necessary to operate the transceiver again in thiscase. BIIS indicationThe following indications are available for the BIIS operationon a BIIS channel.CONNECT : Individual/group call is successful.OK : Message (status or SDM) transmission is suc-cessful.FAILED : No answer back is received.WAIT : Appears during retry of the call (2nd call).CLR DOWN : End the communication.BUSY : Operating channel is in the busy condition. Priority A channel selectionWhen one of the following operations is performed, the trans-ceiver selects the Priority A channel automatically.Priority A is selected when;• Clear down signal is received/transmitted- Set the ‘Move to PrioA CH’ item as ‘Clear down.’• Turning the power ONThe Priority A channel is selected each time the transceiv-er power is turned ON.• Status callThe Priority A channel is selected when transmitting a sta-tus call.- Enable the ‘Send Status on PrioA CH’ item in the BIISconfiguration. Horn outputAutomatic honking function is available when the optionalOPC-617 ACC CABLE is connected. When a status messageis received, the transceiver controls the vehicles horn for thespecified time period to inform a status message is received.This function is convenient when the operator away from thetransceiver.Ask your dealer or system operator, or refer to the servicemanual for connection and setting details.

panel description

I Function display

I Programmable function keys

I Channel selection

I Call procedure

D Transmitting notes

D TX code number edit

D DTMF transmission

user set mode

I Receiving a call

D Group call

I Transmitting a call

D Direct code entry

I Receiving a message

D Received message selection

I Transmitting a status

D General

D Programming an SDM memory

I Position data transmission

I Stun function

I Supplied Accessories

I Mounting the transceiver

I Optional UT-109 or UT-110 installation

I Antenna

Icom IC-F1710 Instruction Manual

i programmable function keys

mdc 1200 operation

i receiving a call

IC-F1710

explicit definitions

PANEL DESCRIPTION

n Function display

n Programmable function keys

n Turning power ON

n Call procedure

transmitting notes

basic operation

n Scrambler function

BIIS OPERATION

group call

n Transmitting a call

n Receiving a message

n Transmitting a status

transmitting an sdm

n Position data transmission

n Stun function

CONNECTION AND MAINTENANCE

n Supplied Accessories

n Mounting the transceiver

n Optional OPC-617 installation

n Antenna

IC-F1810

IC-F2710

IC-F2810