Icom IC-F33GT Instruction Manual

Also see for IC-F33GS: Instruction manual Instruction manual Service manual Service manual Service manual

Icom IC-F33GT Instruction Manual Manual pdf 22 page image

184 BIIS OPERATION■ Transmitting a callTotal of a 3 ways for code selection are available—selectingthe call code from memory, entering the call code from thekeypad and calling back from the queue channel record.D Using call memoryq While in the standby condition, push [P1] (Digital) to enterthe call code memory channel selection mode.• “ ” appears.w Push [UP] or [DOWN] to select the desired call code.e Push [P0] (Call) or [PTT]* to call.* PTT call can be made only when PTT call capability is permitted.NOTE: When no answer back is received, the trans-ceiver repeats the call 3 times (default) automatically,and “ ” is displayed during each call. However, anerror beep sounds and “ ” is displayed when noanswer back is received after the calls.r Push [PTT] to transmit; release to receive.t Push [MONITOR] (Moni(Audi)) to send the ‘Clear down’signal.D Calling back from the queue channelq While in the standby condition, push [P1] (Digital) for 1 sec.to enter the queue memory channel selection mode.w Push [UP] or [DOWN] to select the desired record.e Push [P0] (Call) or [PTT]* to call.*PTT call can be made only when PTT call capability is permitted.NOTE: When no answer back is received, the trans-ceiver repeats the call 3 times (default) automatically,and “ ” is displayed during each call. However, anerror beep sounds and “ ” is displayed whenno answer back is received after the calls.r Push [PTT] to transmit; release to receive.t Push [MONITOR] (Moni(Audi)) to send the ‘Clear down’signal.Call code text is displayed.Appears