113BASIC OPERATIONTurning power ON■q Rotate [VOL] to turn the power ON.w If the transceiver is programmed for a start up password,input the digit codes as directed by your dealer.• 10-keypad can be used for password input depending on ver-sion:• The keys in the table below can be used for password input:• The transceiver detects numbers in the same block as identical.Therefore “01234” and “56789” are the same.e When the “PASSWORD” indication does not clear afterinputting 4 digits, the input code number may be incorrect.Turn the power off and start over in this case.Channel selection■Several types of channel selections are available. Methodsmay differ according to your system set up.NON-BANK TYPE:Push [UP] or [DOWN], or rotate [ROTARY SELECTOR]* toselect the desired operating channel, in sequence; or, pushone of [MR-CH 1] to [MR-CH 4] keys to select a channeldirectly.• Up to 16 pre-programmed channels can be selected via [ROTARYSELECTOR].*BANK TYPE:Push [BANK], then push [UP] or [DOWN] or rotate [ROTARYSELECTOR]* to select the desired bank.AUTOMATIC SCAN TYPE:Channel setting is not necessary for this type. When turningpower ON, the transceiver automatically starts scanning.Scanning stops when receiving a call.*Depending on the pre-setting.KEYNUMBER 0549382716DOWN