Icom IC-F5062D Instruction Manual

Also see for IC-F5062D: Instruction manual Instruction manual Operating guide Instructions

Contents

Icom IC-F5062D Instruction Manual Manual pdf 15 page image

102BASIC OPERATION12345678910111213141516D Transmitting notes• Transmit inhibit functionThe transcever has several nhbt functons whch restrcttransmsson under the followng condtons:- The channel s n the ‘Inaudble’ (mute) mode (“ ” (Aud-ble con) does not appear.)- The channel s busy. However, dependng on the pre-programmed settngs, you can transmt when a call s re-ceved that ncludes an unmatchng (or matchng) CTCSS(DTCS), colour code, or Indvdual or Talkgroup ID.- The selected channel s a ‘receve only’ channel.• Time-out timerIf contnuous transmsson exceeds the pre-programmedtme-out tmer lmt, the transmsson s cut off.• Penalty timerAfter the transmsson s cut off by the tme-out tmer, trans-msson s further nhbted for the pre-programmed penaltytmer perod.D TX code channel selectionIf the transcever has a key assgned to TX Code CH Select,the ndcaton can be toggled between the operatng channelnumber (or name) and TX code channel number (or name).When the TX code channel number (or name) s dsplayed,[CH Up] or [CH Down] selects the TX code channel.USING [TX CODE CH SELECT]:q Push [TX Code CH Select]— a TX code channel number(or name) appears.w Push [CH Up] or [CH Down] to select the desred TX codechannel.e After selectng, push [TX Code CH Select] to set.• Return to the stand-by mode.r Push [Call] to transmt the selected TX code.USING [TX CODE CH UP]/[TX CODE CH DOWN]:If the transcever has a key assgned to TX Code CH Up orTX Code CH Down, the programmed TX code channel canbe drectly selected when pushed.