82OPERATION Turning power ONq Push [ ] to turn the power ON.• A power-up alert tone sounds for about 1 sec. and an openingmessage may appear.w If the transceiver is programmed for a start up passcode,input digit codes as directed by your Dealer.• The keys in the table below can be used for password input:• The transceiver detects numbers in the same block as identical.Therefore “01234” and “56789” are the same.e When the “ ” indication does not clear after in-putting 4 digits, the input code number may be incorrect.Turn power off and start over in this case. Channel selectionSeveral types of channel selections are available. Methodsmay differ according to your system set up.NON-BANK TYPE:Push [CH UP]/[CH DN] to select the desired operating chan-nel, in sequence; or, push one of the [CH 1] to [CH 4] to selecta channel directly.BANK-TYPE:Push [BANK] to select the desired bank number.AUTOMATIC SCAN TYPE:Channel setting is not necessary for this type. When turningthe power ON, the transceiver automatically starts scanning.Scanning stops when receiving a call or when taking the mi-crophone off hook.KEY [P0] [P1] [P2] [P3] [P4]NUMBER 0 1 2 3 45 6 7 8 9

explicit definitions

panel description

I Function display

i programmable function keys

i turning power on

i receiving and transmitting

d scrambler function

I Receiving a call

d displaying the received call record

i transmitting a call

d direct code entry

I Receiving a message

d received message selection

i transmitting a status

i transmitting an sdm

d programming an sdm memory

I PC connection

i auto emergency transmission

I Priority A channel selection

I SmarTrunk II™ and conventional modes

emergency call

CONNECTION AND INSTALLATION

i mounting the transceiver

i optional unit installation

i fuse replacement

OPTIONS

Icom IC-F510 Instruction Manual

I Programmable function keys

I Channel selection

I Receiving and transmitting

D Tx code channel selection

I SmarTrunk II™ operation

d emergency call

i rear panel and connection

I Supplied Accessories

I Mounting the transceiver

d mounting the transceiver

I Optional UT-109/UT-110 installation

I Optional OPC-617 installation

SAFETY TRAINING INFORMATION

IC-F510

front unit.

RECEIVER CIRCUITS

TRANSMITTER CIRCUITS

PLL CIRCUITS

POWER SUPPLY CIRCUITS

PREPARATION

PLL ADJUSTMENT

SOFTWARE ADJUSTMENT

main unit

n function display

n programmable function keys

n turning power on

n receiving and transmitting

d tx code channel selection

d dtmf transmission

n Rear panel and connection

n Supplied Accessories

n Mounting the transceiver

n Optional UT-108 installation

n Optional OPC-617 installation

IC-F520

IC-F521

IC-F610

IC-F620

IC-F621