Icom IC-F5120D Series Instruction Manual

Also see for IC-F5120D Series: Instruction manual Instruction manual Operating guide

Contents

82 BASIC OPERATION■ Turning ON the powerq Push [ ] to turn ON the power.w If the transceiver is programmed for a start up password,input the digit codes as directed by your dealer.• The keys shown below can be used for password input:The transceiver detects numbers in the same block as identical.Therefore “01234” and “56789” are the same.e If the “PASSWORD” indication does not clear after input-ting 6 digits, the input code number may be incorrect. TurnOFF the power and re-enter your password.■ Channel selectionThere are several methods to select channels, and they maydiffer, depending on your system set up.NON-ZONE TYPE:To select the desired operating channel:• Push [CH Up] or [CH Down].• Push one of [MR-CH 1] to [MR-CH 4].ZONE TYPE:To select the desired operating channel:Push [Zone], then push [CH Up] or [CH Down].AUTOMATIC SCAN TYPE:Channel setting is not necessary for this type. When turningON the power, the transceiver automatically starts scanning.Scanning stops when a signal is detected.KEYNUMBER 0549382716