153 IDAS OPERATION■ Transmitting Position dataWhen a GPS receiver is connected to the transceiver, theposition (longitude and latitude) data can be automaticallytransmitted:• When the GPS request status message is received• After sending a voice message- Set the ‘Send with Voice Call’ item to ‘Enable.’• After sending a status message- Set the ‘Send with Status Call’ item to ‘Enable.’• After sending a message- Set the ‘Send with SDM Call’ item to ‘Enable.’• After sending a Call Alert- Set the ‘Send with Call Alert’ item to ‘Enable.’• After sending an Emergency call- Set the ‘Send with Emergency’ item to ‘Enable.’Ask your dealer or system operator for connection details.■ Transmitting Status messagesA status message can be automatically transmitted.A status message is transmitted:• When the transceiver is turned ON or turned OFF- Set a status message to be transmitted in ‘Power ON Status’ or‘Power OFF Status’ item, respectively.- Set the target station ID in ‘Power Status ID.’• After sending a voice message- Set the ‘Send with Voice Call’ item to ‘Enable.’- Set a status message to be transmitted in the ‘Send StatusNumber’ item.■ Sounding a HornThe automatic honking function can be used when a horn isconnected to the transceiver through the optional ACC cableOPC-1939 (D-Sub 15-pin) or OPC-2078 (D-Sub 25-pin).When a status message is received, the transceiver soundsthe vehicle’s horn for the specified time period to inform youthat a status message has being received.This function is convenient when the operator is away fromthe transceiver.Ask your dealer or system operator, or refer to the IC-F5120D/F6120D series service manual for connection and setting details.