Icom IC-F610 Instruction Manual

Also see for IC-F610: Instruction manual Instruction manual Service manual Instruction manual Service manual

Contents

Icom IC-F610 Instruction Manual Manual pdf 16 page image

123OPTIONAL SmarTrunk II™ OPERATIONminating a callompleting a call, push [#] to disconnect (hang up).ORTANT: If one person in the conversation terminatesall, all participants will be cut off.t number re-dialM], [M] to automatically re-dial the last number called.-pitched beep indicates that the number is accepted.mory speed-diallingomatically dial a commonly used number from memory:[M] followed by the memory location (0–9).bo SpeeDialomatically dial a commonly used number with oneone of the turbo SpeeDials ([A], [B], [C] or [D]).gramming memory speed dialh and hold [M] until you hear a high-pitched beep.er the memory location (0–9, A, B, C, D), the telephoneubscriber number, then [1], [M] (or [3], [M] if for anothertem subscriber).igh-pitched beep indicates successful programming.mories [A]–[D] are used for the Turbo SpeeDial.D System busy indicationIf all channels are busy, three low beeps sound after you initi-ate a call. Try the call again later.D PTT dispatch operationq Push [PTT] once (without dialling) to initiate a dispatch call.w Begin talking after you hear three beeps (one short, high-pitched, two very-short, low-pitched).e Receiving a dispatch call is indicated by the same three-beep sequence.• It is not necessary to push [M] to answer a dispatch call.D Emergency callPush [0], [M] to initiate an emergency call.• Contact your dealer for details.D Clear channel alertingIf all channels are busy, the transceiver automatically beginssearching for an open channel and beeps every ten seconds.When two short beeps (low-pitched, then high-pitched) areheard, a channel is available. Push [M], [M] immediately to re-dial the last number.NOTE: For additional operating instructions, contact yourDealer or System Operator..qxd 01.11.28 11:37 AM Page o (1,1)